Spread green with a Solar Battery Charger

In today’s world the solar energy has become an important source of energy for many a people. But most of them do not have clear ideas about the solar power or the solar battery charger. In this article you will have some general ideas about the solar energy and solar battery charger and battery load tester.

Solar power is not the only solution for all the other types of energy for sure. Yet it can be use very effectively. Using the solar unit panel the batteries for the Boat, Trolling Motor, Electric Scooter, RV, House, and Backwoods Cabin all these can be recharged using the solar panel unit. The recharge can be done within few days. The best time for charging anything is the when the panel holds direct sunlight in summer. You can take a 100-amp hour discharged battery and can charge it with a 30-watt solar panel. The thing you need to keep in mind is that the ideal time is summer time with direct sunlight. This will take almost a full week to recharge the battery fully. You can take the example and can use a 100-watt of solar power to recharge the 100-amp hour discharged battery within a few days. You need to make sure there is enough and direct sunlight on the surface of the solar panel to produce the maximum rated power. Weather or climate conditions like overcast sky, equatorial direction, winter, shadows or wrong mounting angle will reduce the actual power rate of the solar panel.

Now, we can know a bit about the voltage rating of the solar power. Most solar units are designed for 12 VDC but there are some limited versions for 24 volt panels. Now, keeping the various amount of requirements of the people there can be special order for solar panels to produce more DC volts like 24, 36, 48 etc.

For the safe use of the solar panel you should use the solar controller if you use the panel to produce over 5 watt rated power. Charge controller is always a good idea in most of the applications. This has the capacity to improve charge quality, prevent sudden overcharge and battery discharge in low or no light situations. If you are using a solar panel that is installed with 6 watt or more solar energy then you must use a controller. A solar controller is like a on and off switch which will allow the power to pass on when the battery needs the solar energy and will cut it off when the battery is fully charged. The solar controllers are typically rated in amps and the photovoltaic panels are rated in watts. So, when you are purchasing one for your solar panel you should keep in mind that the 6 amp controller will act with almost all the solar panel up to the 70 watts.

The manufacturers of the solar panels rate the solar output in watts. In direct sunlight the 15 watt panel can deliver about 1 amp per hour. The SP-panel can deliver one third of an amp per hour. This is good option for proper maintaining the single and dual batteries for stand by and storage applications. The power output is stored in a battery to be used in a later needed time when the solar panel is not producing any energy. These are good for later use and working as filters they also help the sensitive electronics from being damaged at the time of powering. Special battery load tester is available to measure the amount of power in the battery.

When you are using a solar panel you will need to remember that solar power is all about numbers. It depends on the power you need and the amount of power the panel can producer. So, when you are about to buy a power panel you will need to think that how many amps or watts of power you will need for your work in a given period of time. This will be important because you will now need to measure what amount of power would be produced in 24 hours of time. So, you will need to take the given period of time as a baseline to select the solar power panel for you. You can then calculate the direct sunlight the panel will get during that given time. The calculation will help you in weather conditions like panel angel, shade, clouds and other conditions. If you can handle the power requirement status, you can go for a solar calculator.

The panel ratings for solar energy are calculated in direct sunlight. The output will be decreased in cases of overcast sky, clouds, indirect sunlight and shades. You can go for the over-sizing the size of your solar array because such conditions can occur often. Moreover, the sun time for the summer and winter will be different. So, when you are measuring the facts these conditions should be properly taken care of. You can do this as long as the solar panel is designed to be used in such applications and is not sensitive to the variations of voltage. The battery can be used to store the energy for getting constant source of stable and reliable power. You can use the special battery load tester to test whether everything is fine.

A question can come to your mind that whether the solar panels are weather proof or not. Most of the solar panels are designed to install outdoor because this is the best place to get the maximum amount of direct sunlight. When placed otherwise the solar panel is certain to produce less power than the panel is actually rated for.

You should remember that proper maintaining of the solar panel is important when it comes to uninterrupted and reliable solar energy. Periodic removal of dirt, debris and checking the electrical connection can ensure the safe and secure function. For better result, you must clear off the debris, snow and dirt from the solar panel.